Plastic kit of the American multi-stage launch vehicle Saturn V.
Information about templates
On July 16, 1969, the most important journey in human history began. The giant three-stage Saturn V rocket, reaching a height of 110 m, left the launch pad with the aim of transporting a human crew to the surface of the Moon. The Saturn V could carry a payload of 50 tons, reaching a speed of 11.2 km/s.
The 392,000 km journey to the Moon took 72 hours. After reaching low Earth orbit and completing the preparations necessary for the TLI maneuver, the third stage was ignited, giving the ship the necessary speed for the journey to the Moon, whose orbit it reached on July 19, 1969.
Kit characteristics:
- The kit includes 7 basic Humbrol Acrylic paints (5 ml), 2 plastic model adhesives and 2 brushes;
Model specifications:
- scale: 1:144,
- length: 768 mm,
- width: 132 mm,
- number of parts: 79,
- number of decal versions: 1,
- difficulty: 3.
Need to purchase:
Humbrol Acrylic Model Paint (5 ml)
Instructions for use: Water-based acrylic paint. Mix the paint well before use. Apply with a brush directly from the can. When using an airbrush, dilute with a suitable thinner, you can also use water. Two thin layers are better than one thick one. The usual dilution ratio is 2:1 in favor of the paint. Non-flammable base, dries quickly (1-2 hours until completely dry), a little longer in the case of glossy and metallic paints. Using an unsuitable thinner can ruin the paint! Rinse the brush and tools with water immediately after use. Close the container tightly after use. After opening, use as soon as possible, the paint dries with air access. Protect from frost. Contains preservatives 5 Chloro-2-methyl-2H-isothiazol-3-one, 2-methyl-2H-isothiazol-3-one (3:1), 2-phenoxyethanol.
Warning: Keep out of reach of children. Dispose of this material and its packaging at a collection point for special or hazardous waste. Caution! Not suitable for children under 8 years. Children may only use the product under adult supervision.
Poly Cement liquid plastic adhesive (5 ml)
Solvent-based adhesive suitable exclusively for bonding plastic models. Directions for use: Use on common plastics used in model making including polystyrene and ABS. Press the surfaces to be bonded together with gentle pressure until they hold. The bond dries in 10-20 minutes, fully cures in 1 hour. Read and retain.
Warning! Flammable liquid and vapors. May cause drowsiness or dizziness. Repeated exposure may cause skin dryness or cracking. Keep out of reach of children. Avoid breathing vapors. If inhaled: Remove person to fresh air and keep comfortable for breathing. Store in a well-ventilated place. Keep container tightly closed. Caution! Not suitable for children under 8 years. Children may only use the product under adult supervision.
