BETA 1400 is designed for beginners as-always delivered - under the supervision of an experienced pilot, as well as for anyone who wants just so beautiful holiday travels. Its flight characteristics are pleasant and straightforward. Model will acquaint you with full control of the model around all three axes coordinated control with the right rudder, ailerons and elevator. This experience is "like finding" no later than right after you start flying with their first aerobatic models or (semi) scale model of any kind. By changing the ratio of the lengths of servo and rudder deflections can adjust the size of a large range. Beginner, start with small variations, safe and excessive "steerage"; experienced pilot sets the size, allowing a little bit of that větroňové basic aerobatics - loops, barrel rolls, Wing Over Beta going pretty well! The power is sufficient for a lively pitch, while not overly model přemotorovaný, which could create difficulties for novice pilots. BETA 1400 can also be used very strong thermals in the sky and can withstand "all ages".
To power Bety 1400, you will need three-cell Li-poly battery 11.1 V with a capacity of at least 1300 mAh (20C load). Model without problems "can carry" tříčlánky until about 2200 mAh.
ARF kit includes: body molded from EPP with brushless motor mounted, fixed propeller 5x4 "speed controller 20A and 2 servos, wing molded EPP installed with 2 servos, tail of EPP, carbon tube wing joiner and detailed instructions for building and flying .
Setting Controller 1400 Beta Mk II (with transparent cabin)
The controller allows you to enable or disable the propeller brake. Proceed as follows:
First Start with the transmitter and the model off. Turn on the transmitter and move the throttle to full throttle position.
Second The controller, connect the drive battery.
3rd After about 5 seconds you will hear a long beep followed by a short.
4th Download the throttle on the transmitter all the way down.
5th A long and short beeps followed by a trill and a long beep. This is a signal indicating that the brake setting has been changed. The controller is returned to normal operation, you can take off.
6th The above procedure can always change the controller settings from the "brake on" to "brake off" or vice versa.
Setting Controller 1400 Beta Mk.III (with transparent cabin and wing mounting screws)
The controller allows you to enable or disable the propeller brake. Proceed as follows:
First Start with the transmitter and the model off. Turn on the transmitter and move the throttle to full throttle position.
Second The controller, connect the drive battery. After a short while you will hear two beeps.
3rd Download the throttle on the transmitter all the way down.
4th You will hear a beep. This is a signal indicating that the brake setting has been changed. The controller is returned to normal operation, you can take off.
5th The above procedure can always change the controller settings from the "brake on" to "brake off" or vice versa.
Specifications
Span (mm) 1420
Length (mm) 940
Wing area (dm2) 24.5
Weight (g) 650-720
Function V, K, S, M
Difficulty S0/P1-2
Recommended drive and RC equipment
ECO Enduro
Motor * CD2622
Regulator 20A *
Gens Battery 11.1 V 1550 mAh Gens 11.1 V 2200 mAh
* Propeller 5x4 "
* 4x Servos 9 g microservo
RC kit min. 4 channels
*) Part of ARF kit
